Quantum + Bond: peek and control
This solution explains how to use your Quantum Calculator together with Bond.
With this setup, Quantum can send everything typed to Bond for a discreet live peek, and Bond can even control Quantum’s force mode remotely.
What You Need
- Quantum Calculator (charged and turned on)
- Bond (charged and turned on)
- PeekSmith app (latest version, iOS or Android)
Step 1 - Configure Quantum in the PeekSmith App
- Open the PeekSmith app on your phone.
- Go to Devices and connect to your Quantum Calculator.
- Tap on the Quantum settings.
- Scroll to the Force section.
- Turn on PeekSmith Peek.
Now Quantum will send its input and results directly to Bond.
Step 2 - Configure Force Options (Optional)
Inside the Force section of Quantum’s settings, you can fine-tune how Quantum and Bond interact:
- Default Force Number – choose the number Quantum will force when force mode is enabled.
- Allow PeekSmith to Control Force Mode – if turned on, Bond’s buttons can toggle force mode during a performance.
- Slide Switch Toggles Force Mode – allows you to use Quantum’s physical slide switch to enable or disable force mode quickly.
Step 3 - Connect Bond
- Turn on your Bond.
- On the app’s Devices screen, connect to Bond.
- Once both Quantum and Bond are listed as connected, the peek link is ready.
From now on, Quantum’s entries and results will appear on Bond without needing the phone during performance.
Step 4 - Using Peek and Control
- Peeking: Anything typed on Quantum will appear line by line on Bond, including the final result when you press =.
- Controlling Force: If enabled, Bond’s top button can toggle force mode on or off.
- Slide Switch: If enabled, flipping Quantum’s slide switch will toggle force mode.
This gives you full flexibility: peek the spectator’s inputs and secretly influence the final outcome.
Performance Flow
- Spectator performs calculations on Quantum.
- You see every entry and result mirrored discreetly on Bond.
- At any time, you can toggle Force Mode using Bond’s button or Quantum’s slide switch.
- The spectator’s final result matches your force number – or remains free, depending on your control.
Troubleshooting
- Nothing shows on Bond: Make sure PeekSmith Peek is enabled in Quantum’s Force settings.
- Force doesn’t activate: Check if “Allow PeekSmith to Control Force Mode” is turned on, or use the slide switch instead.
- Lag or missing digits: Stay close – Bluetooth range is about 5-10 meters.
FAQ
Do I need the app during the show?
- No. The app is only needed for the initial setup. Once configured, Quantum talks directly to Bond.
Can I change the forced number mid-performance
- Yes, in Quantum’s settings you can set a default number. You can also temporarily override it during routines.
What if I only want to peek, without control?
- Just enable PeekSmith Peek and leave the control options off. Then Bond will act as a display only.
Can I use multiple PeekSmith devices at once
- No, only one PeekSmith device (PeekSmith 3 or Bond) can be connected directly at a time.
How-Tos
📃 Basics
📃 PeekSmith 3 + IARVEL Post-It Pad: peek drawings
📃 MrCard + IARVEL Post-It Pad: peek drawings
📃 Atom + Teleport: Revealing ESP cards
📃 Quantum + PeekSmith App Monitor: peek screen
📃 Quantum + PeekSmith 3: peek and control
📃 Quantum + Bond: peek and control
📃 Atom + SB Watch (Set the Time)